Pacific Seacraft 40 Pilothouse
Features and Equipment

    FEATURED EQUIPMENT
    • Cutter Rig:
      Harken Roller Furling Unit 2.0 on Headsail
      Harken Roller Furling Unit 1.0 on Staysail
    • Single handers Package for Cutter Rig Main halyard and 2 sets of reefs led aft
    • Chrome Plated Bronze Deck Hardware
    • B&G Network Instruments:
      Speed/Log/Temp/Depth/Wind in cockpit
      Data repeater at interior helm
    • Windscreen overhead console for instruments
    • Sea Frost BD3 DC Refrigeration
    • Whitlock Pedestal Steering-Single Lever Throttle
    • Ritchie Pedestal Compasses (Cockpit, Interior helm)
    • Heart Freedom 20 Inverter/Battery Charger
    • Standard Horizon VHF Radio w/ Masthead Antenna
    • Lightning Ground System
    • SSB Radio Copper Ground System
    • Bluewater Full Batten 9 oz. Mainsail w/ 2 reefs and Lazy Jacks
    • Bluewater Roller Furling 8 oz. Staysail w/ UV Cover
    • Bluewater 120% Roller Furling 8 oz. High Clew Genoa w/ UV Cover
    • Solid Boom Vang
    • Windshield Wipers & Defrosters at Interior Helm
    • All Windows & Ports are Tempered Glass
    • Boman Windows in Pilothouse (2 opening)
    • Force-10- 3 Burner Propane Stove w/ Oven & Broiler
    • Hot/Cold Fresh Water Cockpit Shower
    • Raw Water Anchor/Deck Wash
    • Epifanes Polyurethane Varnish on Interior Teak
    • Louvered doors with
    • Teak Oil on Exterior Woodwork
    • Corian Countertops in Forecabin, Galley, Head, & Aft Stateroom
    • Choice of Decorator Upholstery
    • All Formica Bulkheads with Teak Trim

      (Back To Top)
    CONSTRUCTION (To ABS Approved Plan Certification)
    • Hand laminated hull and molded in gel coat color.
    • First hull laminate uses vinylester resin for superior blister resistance.
    • Biaxial fiberglass hull.
    • Balsa core from waterline to sheer.
    • Standard hull & deck colors are Oyster White.
    • Choice of boot & sheer stripe colors.
    • Upper and intermediate shrouds to stainless steel chainplates and backing plates caulked and thru-bolted to the hull.
    • Lower shroud chainplates set inboard for ease of movement.
    • Solid teak rub-strake on hull.
    • Rudder with steel web frame supported by high strength manganese bronze gudgeon and closely coupled to steel reinforced integral skeg.
    • Ballast-8,880 pound (4.04 m) solid lead casting permanently attached w/ stainless steel keel bolts and backing plates.
    • Keel to hull joint bedded in epoxy.
    • Primary bulkheads bonded into hull & deck w/ fiberglass & thru-bolted.
    • Underside of deck, lockers and entire bilge are gel coated to prevent mildew and to facilitate cleaning.
    • All bulkhead openings for hoses and wiring are rubber grommeted to prevent chafing.
    • Deck to hull connection-Integral hull & deck flanges mated and bedded in polyurethane and fastened with stainless steel thru-bolts.
    • Deep bulwarks with heavy teak cap rail, hand fitted with butterfly joints.
    • Deck balsa cored. Plywood core in hardware mount areas.
    • Deck has molded-in non-skid pattern. All exterior teak is oiled.

      (Back To Top)
    DECK EQUIPMENT
    • All cleats, winches, turning blocks, pulpits & stanchions are thru-bolted with metal backing plates and caulked on both sides with polyurethane.
    • 30' high stainless steel double rail bow and stem pulpits with running lights and 30' high double lifeline stanchions.
    • Stainless steel boarding gates, port and starboard, with double lifelines.
    • Extended stainless steel bow platform and stem fitting with two heavy-duty anchor rollers & locking pins.
    • Divided bow chain locker for two anchor rodes w/ one anchor deck pipe.
    • Stern chain locker to starboard with deck pipe and stern anchor roller.
    • Chrome plated bronze deck hardware includes: All hinges, hasps, jam cleats, chain pipes, deck fills, etc.
      Two Harken #53.2 STC two speed, self-tailing genoa sheet winches.
      One Harken #44.2 STC two speed, self-tailing mainsheet winch.
      Three Harken #40.2 STC 2 speed, self-tailing halyard & utility winches.
      Two 7" x 12" and eight 4" x 7' opening ports (2 in cockpit).
      Two 12" and two 10' bow mooring cleats (4 total), 3' hawse pipes.
      Two 10" open spring cleats amidships.
      Two 10" stern mooring cleats with 9' chocks.
      One anchor deck pipe on foredeck, and one aft.
    • Harken mainsheet traveler over companionway hatch on pilothouse.
    • Harken deck sheave organizers.
    • Lewmar rope clutches.
    • One large Bomar double opening hatch forward & four Bomar vent hatches.
    • Two dorade ventilators.
    • Six teak handrails on cabin house.
    • Outboard genoa tracks with Harken lead cars.
    • Harken foot blocks.
    • Fiberglass seahood for companionway sliding hatch.
    • Hinged and locked entry door with window.
    • Stern mounted stainless steel swim ladder with teak treads and boarding gate.

      (Back To Top)
    INTERIOR
    • White Formica cabin house trunk sides.
    • Varnished woodwork.
    • 6'5" headroom with teak and holly sole throughout cabin area.
    • Push button positive latches on 611 locker doors.
    • White matte finish below counter height, teak cabinetry above.
    • Spun polyester wrapped foam cushions with choice of fabrics.
    • Zippered vinyl headliner with superior insulation, deadens sound and provides easy access to deck hardware and wiring.
    • All hanging lockers cedar lined with louvered doors.
    • Forecabin:
      6'7" long and 57' wide double island berth with drawers and shelves.
      Teak ceilings above shelves.
      Teak bi-fold privacy door.
      Vanity sink, mirror and large hanging locker.
    • Main Salon:
      Outboard are teak lockers and book shelves above seats, storage bins below.
      Wet locker to starboard.
      7'5" long teak dinette table to port converts to double berth.
      Contoured vinyl helm seat. Teak navigators desk w/ storage under lift top.
      Electronics panel & book shelves.
    • Enclosed head:
      Full size ceramic head with macerator to holding tank.
      Corian counter,stainless steel sink, drawers and lockers.
      Non-skid flooring, separate shower stall, & numerous dry storage lockers.
    • Aft Stateroom:
      Enclosed aft stateroom with 6'7' long and 54" wide double berth.
      Teak privacy door separating aft stateroom from main salon.
      Large hanging locker with drawers under berth.
      Vanity mirror. Teak ceilings above full length book shelf.
    • Galley:
      Gimbaled stainless steel three burner propane stove w/oven & broiler.
      Stainless steel safety bar/towel rack.
      Formica stove top.
      Large ice box w/foam insulation, hinged lid & manual pump out to sink.
      Polished stainless steel double sink with manual pump pressure fresh water & foot operated manual pump.
      Corian countertop.
      Food and dish storage lockers and drawers.

      (Back To Top)
    PLUMBING
    • Multiple water tanks w/inspection ports, approx. 140 gallons (589.5 liters).
    • Hot and cold pressure fresh water system for galley, head and shower.
    • 6 Gallon hot water heater from engine heat exchanger or shore power.
    • Bronze thru-hull fittings with U.L. approved bronze seacocks below the waterline, and bronze ball valves above waterline.
    • All under water thru-hull hose connections are double hose clamped.
    • Marine head with 20 gal. holding tank, macerator, and overboard pump-out.
    • Electric shower sump pump with overboard discharge.
    • Electric automatic bilge pump with Ultra float switch.
    • 25 GPM manual bilge pump in cockpit operable by helmsman.

      (Back To Top)
    ENGINE
    • Yanmar 4JH3TE, turbo four cylinder, 62 hp diesel w/ fresh water cooling, electric stop and 80 amp alternator.
    • Light in engine room.
    • Clear covered engine control panel in cockpit by helm with tachometer, engine hour meter and engine condition indicators.
    • Two aluminum fuel tank approximately 60 gals. ea. (227.4 liters) with gauges and cleaning ports.
    • Three blade solid bronze propeller.
    • Mechanical fuel pump, electric back up fuel pump.
    • Racor MA400 fuel filter.
    • Seawater strainer bulkhead mounted and water lift muffler system.

      (Back To Top)
    ELECTRICAL
    • AC/DC master power control panel with AC ammeter, AC voltmeter, DC voltmeter, polarity test circuit, 8 AC circuit breakers, 12 open AC switches, DC ammeter, battery condition monitor, 20 DC circuit breakers, 4 open DC switches.
    • Tinned copper wiring throughout.
    • 110 Volt shore power system.
    • Three Lifelinedeep cycle marine batteries (105 amps ea.) below cabin sole.
    • Two 4 position battery switches.
    • Appropriate dome lights and reading lights. One adjustable chart light at navigation desk.
    • AC duplex receptacles and GFI protection for 110 Volt .
    • VHF coaxial antenna cable led from masthead to navigators table.

      (Back To Top)
    COCKPIT
    • 7' long seats with contoured seat backs and seat drains.
    • Coamings have two built-in winch handle boxes, one is for shower.
    • Cockpit seat locker for storage.
    • Two chrome opening portlights.
    • Starboard lazarette hatch and vented propane locker for two tanks.
    • One 5 gallon/20 pound propane tank (empty) with stainless steel mount bracket.
    • Two safety harness pad eyes in cockpit.
    • Whitlock Mamba pedestal wheel steering with brake and offset stainless steel pedestal guard, single lever throttle controls.
    • Emergency tiller.
    • Removable cockpit sole w/neoprene gasket sea, finger pulls, and four chrome retainers for access to engine, steering and packing gland.
    • Two 1-1/2" drains in cockpit sole to seacocks for fast self-bailing.

      (Back To Top)
    SPARS AND RIGGING
    • Custom aluminum spars with white two part linear polyurethane paint.
    • Double airfoil spreader rig with 6 sheave offshore masthead, 2 spinnaker cranes, internal halyards (main, headsail, spare headsail, spinnaker), staysail double sheave box, internal lazy jacks, and whisker pole track.
    • 2 Harken halyard winches: #40.2 STC headsail, #32.2 STC staysail.
    • Stainless steel Mast collar to lead lines aft.
    • Anchor light on masthead, spreader and bow/foredeck lights on mast.
    • Internal conduit with VHF coax cable and wires.
    • Two sets of reef gear with independent tacks & clews. Internal 4:1 outhaul & adjustable boom topping lift exit to cleats on boom.
    • 1 x l9 stainless steel standing rigging.
    • Color coded dacron running rigging. Forged chrome bronze open body turnbuckles.
    • All Harken blocks.

      (Back To Top)
    SPECIFICATIONS
      LOA (including bowsprit) 42'-2" 12.85 m
      LOD 40'-4" 12.22 m
      LWL 31'-3" 9.53 m
      BEAM 12'-5" 3.78 m
      DISPLACEMENT (Light local sailing) 24,500 lbs. 11.15 m
      DRAFT-STANDARD 6'-l" 1.85 m
      -SHOAL (bulb) 5'-2" 1.57 m
      LEAD BALLAST-STANDARD 8,600 lbs. 3.91 m
      -SHOAL(bulb) 8,880 lbs. 4.04 m
      SAIL AREA, CUTTER 998sq.ft 74.52 sq.m
      I = 49.5' 15.08 m
      P = 43.5'1 3.26 m
      J = 18.4' 5.61 m
      E = 18.0' 5.49 m
      MASTCLEARANCE 55'-0" 16.76 m
      HEADROOM 6'6 1.96 m
      BERTHS 6

      Specifications subject to change without notice
      Effective December 1, 2000.

      (Back To Top)